Wixx 2K Epoxy 550 Concrete Paint

Wixx 2k Epoxy 550 concrete paint is a high-quality 2-component solvent-based concrete coating that has been specially developed for intensive and chemical stress. This professional concrete paint is ideally suited for:

• Concrete floors in garages
• Workshop floors
• Parking garages
• Showrooms
• Galleries
• Production floors in factories and workshops
• Warehouse floors and storage spaces

Therefore, for an optimal liquid-tight floor that is resistant to chemicals, oils, greases and tyre plasticisers, we recommend first applying 1 coat of Wixx 2K Universal Primer. Subsequently, you should apply 2 coats of Wixx 2K Epoxy 550 concrete paint. This will give you a completely liquid-tight floor that is also very easy to clean.

Properties

• Satin finish
• Very easy to apply thanks to the long open time
• Pot life is approximately 90 minutes
• Drying time is approximately 16 to 24 hours
• Recoatable after approximately 24 hours
• Light traffic after 48 hours
• Fully trafficable after 72 hours
• Important: the floor is only chemically cured after 96 hours and can only then be cleaned chemically
• Coverage is approximately 5m2 per litre, depending on the substrate
• Ratio is 4:1 | 8L concrete paint and 2L hardener
• Available in 15 different colours

Substrate preparation:
First, every substrate must be thoroughly cleaned with Wixx Super Degreaser and then rinsed with water. The surface must be completely clean. The advantage of Wixx Super Degreaser is that it also makes the floor antistatic, ensuring optimal adhesion.

Application:
Wixx 2k Epoxy 550 concrete paint can be applied with roller, brush or airless spray. If you use spray, dilute 5% with Epoxy thinner. Clean very thoroughly with Epoxy Thinner or White Spirit/Turpentine after use.

Thinning/Cleaning
Wixx 2K Epoxy 550 concrete paint may be diluted with a maximum of 5% Epoxy Thinner. Can be cleaned with Epoxy Thinner or White Spirit/Turpentine.

Primer:
We always recommend applying a coat of Wixx 2K Universal Primer first. This removes the absorption from the substrate and optimises adhesion.